LAST UPDATED: November 19/2019
DO NOT FORGET TO REFRESH YOUR BROWSER
IF YOU HAVE BEEN HERE BFORE
DIMENSIONS OF COMPONENTS
In order to establish proper drawing controls the following is expected from ALL of us:
Please compare the listed dimensions of the components to OUR last valid drawings,
check for accuracy.
If errors are found, corrections needed or changes are requested, Fred Jiran expects IMMEDIATE notification via e-mail or phone call and he will in return do the same.
Fred Jiran will then remove the drawing(s) in question and replace them with corrected version(s).
NOTE:
WHAT IS SHOWN ON THESE PAGES IS WHAT CODEVO LLC IS CONSTRUCTING
Note: unless specifically noted on drawings, we will work to a tolerance of 0.125" (1/8")
We expect and hope, that the final, assembled dimensions of the components will be within + - 0.25" (1/4") at critical locations.
If any of these sketches are not properly describing the components being built, ask for further details!
CLICK ON THE THUMBNAILS TO SEE FULL PAGE DETAILS
use the "return" on your browser to get back
click the Pic to enlarge
Sky Space cross section |
PARTS ARE FINISHED |
ALL 360 deg. ARE BUILT |
Oculus Deck moving over ON HOLD |
MT |
MT
|
||
HORIZON ROOM TOP VIEW DIMS OUTSIDE DIMENSIONS |
HORIZON ROOM TOP VIEW DIMS OUTSIDE DIMENSIONS |
RETURN TO BALSON PROJECT FIRST PAGE